1.Purpose of the job

This function will require an initial working period in Lommel of 3-6 months and after this period frequent

visits to Lommel and the other ZFWP plants.

________________________________________

2.Major accountabilities

1. Lead the standardization & improvement of the complete Q calibration system and itruments for manual measurements at optimal cost & effectiveness across IW;

2. In charge of the calibration procedures and calibration system for all QA and QC itruments, equipment and machines, from dial gauges and torque tools to CMM’s and multi-megawatt test benches;

3. Will be the specialist in determination of measuring uncertainty of QC itruments.

respoible for the standardization of manual ipection itruments used in production gea, castings, assembly, test… : from selection, development of specific itruments, measurement system analysis and Gauge R&R improvement to user itructio, including temperature compeation and itructio for periodic verification on the shop floor;

4. Coordinate the development & maintenance of QC/QA calibration procedures and user itructio for manual itruments & training material;

5. Follow up market & developments in relevant areas; maintain contact with ZF, ISO, FVA, ...

6. Lead (dotted line) a team of plant calibration staff of all ZFWP plants to organize / plan / delegate input for IW procedures, MSA improvements, training material… and to eure adherence to agreed standards;

7. Support & audit plant calibration of all ZFWP plants with expert knowledge,supporting selection & usage introduction of new itruments, calibration tools and software / Co-monitor technical status of these itruments is also part of respoibilities;

8. Maintai all applicable files and documents;

9. Identifies and promotes opportunities for improvement with regards to job function or otherwise;

10. Other respoibilities as assigned by supervision.

_______________________________________

3.Behavioural Competencies & Skills

1. Challenging attitude to existing calibration procedures and selection / use of manual itruments: focus on continuous improvement, standardization and cost-effectiveness; ability to compose clear calibration and operating itructio and procedures;

2. Good motivational skills (non-hierarchical leadehip);

3. Good communication skills (English), both verbal and written, to all levels in BU;

4. Prepared to travel 10 - 20% of time;

5. Ipection skill is preferred;

6. Familiar with automotive industry standard of ISO/TS – advantage.

________________________________________

4.Technical Competencies & Skills

Senior engineer with deep technical and practical knowledge of manual measurement itruments and calibration of a wide range of itruments and equipment; good knowledge on standards on measuring uncertainty, MSA, calibration and calibration database software.

________________________________________

5.Expertise

1. Bachelor’s Degree in mechanical engineering；

2. 3-5 yea of wind power or automotive industry related Quality Management Experience.